Product identification
Product: WakeClip
Product type: WC-01
Material: PETG
Product weight: approximately 5 g
Country of manufacture: Germany
WakeClip is a 3D-printed lid spacer designed for the specific MacBook model selected when ordering. It is model-specific and is not a universal accessory. Every model variant currently selectable in this shop has been tested with the listed MacBook model.
Safety instructions
- Use only with the exact compatible MacBook model selected when ordering.
- Never use force when fitting or removing WakeClip, and never press the display lid against the spacer.
- Do not use a damaged, deformed or loose WakeClip. Stop using it if sharp edges or heat damage appear.
- Keep the contact surfaces clean. Check the product and the MacBook contact area before each use.
- Do not operate a Mac with WakeClip fitted inside a bag, sleeve or another confined, unventilated space.
- Do not transport the Mac in a bag or sleeve while WakeClip is fitted.
- Do not combine WakeClip with a protective case unless the combination has been expressly confirmed as compatible.
- Keep away from small children and pets. Small product — choking or ingestion hazard.
- Keep away from excessive heat, open flame and aggressive chemicals.
Manufacturer and safety contact
Kenan Sagir – sole proprietorship
Brand: WAKECLIP
Marienstraße 49
50767 Cologne
Germany
Email: support@wakeclip.com
Phone: +49 159 06486118
WakeClip is an independent accessory and is not affiliated with, sponsored by or endorsed by Apple Inc.